The dial is turned from the same piece of 316L stainless steel as the back rehaut.
Turning the outside to diameter.
Facing the interior, as the dial will have a section profile as an 'L'.
Further facing of the dial.
Swarf is continuously building up.
Further cuts, more swarf.
Stainless, like aluminum, gums up very quickly as it heats up, so turning on the lathe is a bit taxing.
Dial area finished.
Parting off of the dial.
The dial was parted off. It was caught with a steel rod held in my other hand.
The case body, dial and back interior bezel.
